POWER7 information

Displaying data for functions 63 and 64

Use this procedure to collect data. Each function has a different amount of data to collect. Collect the data for the range that is listed for each function in the following table.

Table 1. Data collection ranges. Functions 63 and 64
Function Description Range
63 Status SRC trace 6300 to 6318
64 Diagnostic SRC trace 6400 to 6420
Parent topic: Low-level debug and data collecting procedures

Record the data

Use the following procedure and record the data as shown.
  1. Press the Increment (↑) button until the function you want appears in the Function display (example: 63).
  2. Press Enter on the control panel; ** appears next to the function number to indicate that you are in the sub-function mode. This is the entry point and exit point for sub-function mode).

    If the data is xx _ _ _ _ FF (where xx = the function number), this function is not available.

  3. Press the Increment (↑) button until 00 is next to the function number.
  4. Press Enter on the control panel. Data appears in the display. Record the data.
  5. Press the Increment (↑) button to continue to the next sub-function (example: 5401).
  6. Press Enter on the control panel. Record the data.
  7. Repeat steps 5 and 6, increasing the sub-function number one at a time and recording the data until all the suitable data is collected.
  8. Press the Increment (↑) or Decrement (↓) buttons to move from the last sub-function back to ** (example: 633F to 63**).
  9. Press Enter on the control panel. Doing this takes you out of sub-function mode, and ** no longer appears.

Repeat steps 1 through 9 for additional data that you were instructed to collect.

Call your next level of support and give them the information you collected to write a Licensed Internal Code APAR.


Send feedback Rate this page

Last updated: Wed, September 28, 2016