Installing the 0595, 5095, or 7311-D20 expansion unit into a rack

You might need to install an expansion unit into the rack. Use this procedure to perform this task. In addition to information intended to promote safety and reliable operation, illustrations of the related hardware components are provided, and these show how the components relate to each other.

This procedure assumes that you are installing the model 0595, 5095, or 7311-D20 expansion unit into an existing rack. If the rack is not installed, follow the instructions in Installing the rack, and then return to this procedure for instructions on installing the expansion unit into the rack.

Note: This procedure applies only to the models that are designed to be mounted in a rack. Do not attempt to install a stand-alone model in a rack.

To install the 0595, 5095, or 7311-D20 into a rack, complete the following steps:

Read the Rack safety notices.
Unpack the template and rack hardware.

Figure 1. Unpacking the rack template and hardware
Complete a parts inventory (See Completing a parts inventory).
Determine where the expansion unit should be located in the rack. See Determining the location.
Mark the location. See Marking the location without a rack-mounting template.