Slide the cover latch (A) to disengage
it from the pivot pin (C) as shown in the following
figure.
Lift the cover (B) off the pivot pin.
Slide the cover off the cassette.
Figure 1. PCI
adapter cassette cover removed
Remove the adapter from the cassette by doing the following:
Unlock the adapter retainers by rotating the retainer clip (A) into
the horizontal position. See Figure 2.
Note:
The edge of the adapter located at the end of the cassette that
contains the cassette handles is called the adapter tailstock.
Two retainers are located at the top of the cassette, along the
top edge of the adapter. Two more retainers are located at the edge
of the cassette opposite of the adapter tailstock.
When the retainer clip is in the horizontal position, the adapter
retainers are unlocked and can slide away from the card.
If the corner support retainer is used, unlock it, and then slide
the corner support retainer away from the card.
Push the adapter retainers (B) away from
the adapter.
Unlock the adapter tailstock clamp (C).
Rotate the adapter out of the cassette by grasping the edge of
the adapter opposite the tailstock, and then firmly rotate the adapter
toward the bottom of the cassette.
Lift the adapter out of the tailstock retaining channel.
Figure 2. Adapter removed from the PCI adapter cassette
Put the adapter in a safe place.
Attention: A cassette
containing either a PCI adapter or filler panel must be placed in
the PCI adapter slot of the system unit for proper air flow and cooling.