Installing the 7310-CR47042-CR4 into a rack

This section describes how to install the 7310-CR47042-CR4 into a rack. This is a customer task. You can perform this task yourself, or contact a service provider to perform the task for you. You might be charged a fee by the service provider for this service.

This procedure assumes that you are installing the 7310-CR47042-CR4 into an existing rack. If the rack is not installed, go to the instructions for installing a rack and then return to this procedure for instructions on installing the system unit into the rack. See Install a rack.

To install the 7310-CR47042-CR4 into a rack, complete the following steps:

1. Complete a parts inventory. See Complete a parts inventory.
2. Locate the rack-mounting hardware kit and the system rail assemblies that were included with your system unit.

Figure 1. Rail Kit

Table 1. Rail kit parts

Sliding-rail kit parts
A Slide rails
B Cable-management arm mounting plate
C Cable-management arm
D Cable-management bracket
E Cable-management support bracket and security tab
F Latch strikes (2)
G Screws (6)