Preparing the 5104-22C, 9006-22C, or 9006-22P system for operation after you remove and replace internal parts

To prepare the system for operation after you remove and replace internal parts, complete the steps in this procedure.

Procedure

  1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged into a ground jack or connected to an unpainted metal surface. If not, do so now.
  2. Replace the service access cover. For instructions, see Installing the service access cover on an 5104-22C, 9006-22C, or 9006-22P system.
  3. Place the system into the operating position. For instructions, see Placing an 5104-22C, 9006-22C, or 9006-22P system into the operating position.
    (L012)
    Pinch hazard
    CAUTION:
    Pinch hazard. (L012)
  4. Reconnect the power cords to the system. For instructions, see Connecting the power cords to an 5104-22C, 9006-22C, or 9006-22P system.
  5. Start the system. For instructions, see Starting the 5104-22C, 9006-12P, 9006-22C, or 9006-22P system.
  6. If you installed or replaced a PCIe adapter, update the adapter firmware.
    See Getting firmware fixes for vendor I/O adapters from the vendor website.
  7. Verify the installed part.
    For instructions, see Verifying a repair.