Placing an 9006-12P system into the operating position

Learn how to place an IBM® Power® System LC921 (9006-12P) system into the operating position.

About this task

CAUTION:
or or

The weight of this part or unit is between 18 and 32 kg (39.7 and 70.5 lb). It takes two persons to safely lift this part or unit. (C009)

Procedure

  1. Using two people, one on each side of the system, lift the system from the table.
  2. Align the system rails on each side of the system with the rack rails.
  3. Push the system into the rack until you hear each rail click into place.
  4. Before releasing your hold on the system, ensure that the rails are engaged by sliding the system forward into service lock position. Check that the rails are properly seated. If the rails are not fully engaged, the system could drop.
  5. Release the rail safety latches (A) by lifting them upward, as shown in Figure 1, then push the system fully into the rack.
    The safety latches work in opposite directions; the latch on one side moves up while the latch on the other side moves down.
    Figure 1. Placing the system into the operating position
    Placing the system into the operating position
  6. Fasten the two front screws (C) to secure the system to the rack.
  7. Using your labels, reconnect the cables at the rear of the system unit.