Connecting multiple racks with the rack-to-rack attachment kit for a 24-inch pitch

You might need to connect multiple racks together.

1. Read the Rack safety notices.
2. If they are installed, remove the side panels from each rack. Remove side panels only from the sides that you are attaching to each other by completing the following steps:
   1. Remove the screws on the top and insides of the rack.
   2. Pull the panel up and away from the rack chassis. This motion releases the panel from the lower J bracket.
   3. Store the side panels.
3. Remove the J-bracket screws (A) and bracket (B).
4. Use two screws (D) to install the spacer bracket (C, in front). Align and install the rear spacer bracket (C), as shown in Figure 1.
   Figure 1. Removing the side panels, bracket, and standoffs to connect multiple racks

   

   Item	Description
   A	M5x16 Hex flange screw
   B	J bracket
   C	Spacer bracket
   D	M5 hex flange screws
   E	M8x35 screw
   F	Washer
   G	M8x45 screw

5. Position the racks together.
6. Align the rack holes. If the rack holes do not align, adjust the leveling feet.
7. Install a screw (E/G) and washer (F) into all four positions, but do not tighten.
8. Ensure that all your racks are aligned, and then tighten all four screws.
9. Connect the cables that go between the racks.
10. If necessary, install a side panel on the end rack. For more information, see Installing the side cover.
11. If you are installing stabilizer brackets, go to Attaching the stabilizer bracket.