Creating hot spare disks
Follow this procedure to create hot spare disks.
- Start the IBM® SAS Disk Array Manager by following the steps in Using the Disk Array Manager.
- Select Change/Show SAS pdisk Status.
- Select Create a Hot Spare.
- Select the appropriate controller.
- Select the pdisks that you want to designate as hot spares. A screen summarizes your selections.
- Press Enter to create the hot spares.
The disk state changes to Hot Spare. On subsequent
disk failures, reconstruction of failed disks will occur automatically
for RAID 5, 6, 10, 5T2, 6T2, and 10T2 disk arrays.
Note: If there is
a degraded disk array at the time that a hot spare is configured,
reconstruction of the Failed disk begins automatically.
