Learn how to remove a Small Computer System Interface (SCSI)
disk drive filler from the server or expansion unit.
Note: Some of the figures in this procedure might not look
exactly like the system or expansion unit that you have. However,
the steps to complete the task are the same.
- Remove the system unit door, expansion unit door, or open
the rack front door.
- Remove the front cover.
- Identify the disk drive filler you want to remove.
- Pull the disk drive filler from the slot. Pull
the disk drive filler from the slot that you want to use, as shown
in Figure 1.
Attention: - Attach a wrist strap to an unpainted metal surface of your hardware
to prevent electrostatic discharge (ESD) from damaging your hardware.
- When using a wrist strap, follow all electrical safety procedures.
A wrist strap is for static control. It does not increase or decrease
your risk of receiving electric shock when using or working on electrical
equipment.
- If you do not have a wrist strap, just prior to removing the product
from ESD packaging and installing or replacing hardware, touch an
unpainted metal surface of the system for a minimum of 5 seconds.
Figure 1. Removing a disk drive filler from a model or 7311-D20
- Gently pull off the disk drive bezel latch (A) from
the front of the filler, as shown in the following figure.
Figure 2. Removing a disk drive bezel
- Loosen and then pull out on the thumbscrew (C) to
release the bezel (B) from the front edge of
the filler.
Subscribe to this information
