subscribe iconSubscribe to this information
IBM PowerLinux information

FSPSP50

A diagnostic function detects a connection problem between a processor chip and a GX chip. If replacing the FRUs previously listed in the FRU list does not fix the problem, perform the following steps:

  1. Power off the system. See Powering on and powering off the system.
  2. Use the following table to determine the action to perform.
    System: Action:

    8246-L1C, 8246-L1D, 8246-L1S, 8246-L1T, 8246-L2C, 8246-L2D, 8246-L2S, or 8246-L2T

    		 Replace the system backplane at location Un-P1. See System FRU locations for information about locating the system backplane.
  3. To determine the action to perform, use the following table.

    8246-L1C, 8246-L1D, 8246-L1S, 8246-L1T, 8246-L2C, 8246-L2D, 8246-L2S, or 8246-L2T
    Power on the system to the hypervisor standby.
    Note: Slow boot is not supported.
    This ends the procedure.
Parent topic: Service processor isolation procedures

Send feedback Rate this page

Last updated: Thu, July 23, 2015