Use this procedure to place the rack-mounted system into
the operating position.
When placing the system into operating position, ensure that
the cables at the rear of the system do not catch or bind as you push
the system unit back into the rack.
- Unlock the blue rail safety latches (A) by lifting
them upward. The rail safety latches are located near the
middle of the system.
Figure 1. Placing the system unit into the
operating position
- Push the system unit (B) rear into the rack until
both system-unit release latches have locked into position.
- Replace and tighten the two screws (if present) (A) that
secure the system unit (B) to the rack.
Note: Replacing
the two shipping screws is optional but should be done in geographic
areas that are prone to seismic activity.
- Close the front rack door of the unit you are servicing.
Figure 2. Placing the system unit into the operating position