Function Code 9: Display Error Code Log

Function Code 9 displays the last ten error codes, one at a time (the codes are ordered; the most recent is presented first and the oldest is presented last). If there are no errors in the log, function code 0 displays in the Single-character Display (SCD) and exits Maintenance Mode.

1. Place the drive in Maintenance Mode. For instructions, see Entering Maintenance Mode.
2. Press the Unload Button once per second until 9 appears in the SCD. (If you cycle past the code that you want, press the Unload Button once per second until the code reappears.)
3. Press the Unload Button, then release it to view the most recent error code.
4. Press and release the Unload Button again to view successive error codes. Let two to three seconds pass between each depression. The Green Ready LED and Amber Fault LED will flash On/Off once for each successive error code. The SCD will display 0 when all the error codes have been displayed.
5. After viewing all error codes, exit this function by pressing the Unload Button again. The SCD will display 0 and exit Maintenance Mode.