To set the IP address on Linux operating
system, complete these steps.
During this procedure, you need the IP address you obtained
in step
4 in Accessing
the ASMI using a Web Browser.
- Make sure that you are logged on as a root user.
- Start a terminal session.
- Type ifconfig -a at
the command prompt.
Attention: Record or print
the current settings and the eth1 or eth2 interfaces before making
changes. This action allows you to restore these settings if you disconnect
the PC or notebook after setting up the ASMI Web interface.
- Type ifconfig ethx xxx.xxx.xxx.xxx netmask xxx.xxx.xxx.xxx,
where the xxx.xxx.xxx.xxx values are the values from step 4 for IP address and
Subnet mask. Replace ethx with the interface
shown in step 3.
- Press Enter.
