Disable settings before you install the ICFM tools client. Note
that after installation completes successfully, you can restore your
previous settings.
Procedure
To configure the firewall settings:
- Open a command prompt in "Run as administrator" mode (or
PowerShell) and enter:
netsh advfirewall set allprofiles state off
- To verify that Windows Firewall
for all networks is off, enter:
netsh advfirewall show all
The
state should indicate off for Domain, Private, and Public profile
settings.
Attention: After you complete installation
of the
ICFM tools
client, you can re-enable the firewall with the following command:
netsh advfirewall set allprofiles state on
- If Microsoft (Windows Defender®) or any third party (Norton by
Symantec, McAfee, and so on) antivirus software is enabled, you must
disable this software before you install the ICFM tools client. You
can re-enable the antivirus tool after installing the ICFM tools client.