Debugging the message flow in simulation mode

Compile, deploy, test, and debug the message flow that includes your user-defined node.

About this task

You can compile, deploy, test, and debug the message flow that includes your user-defined node in the same way that you test any regular subflow. However, you must set a breakpoint so that the debugger stops at that point, see Working with breakpoints in the flow debugger.

You can debug the message flow only if the following constraints are met:

The user-defined node project must be in the workspace.
The user-defined node project must be in the simulation mode.
The subflow cannot be debugged after it has been exported as a plug-in, unless the source code is in your workspace.