Installing the add-ons package in console mode

The add-ons package must be installed by the application administrator on a Windows 32-bit operating system or a Windows 64-bit operating system.

1. Log on as application administrator on the system where you want to install the add-ons package.
2. Insert the product DVD and then change to the Windows32 directory on the DVD.
3. On a command prompt, enter the following command to install IBM® Installation Manager and the add-ons package:

   userinstc -c

4. Complete these steps on the console:

   Section	Procedure
   Install	All packages are preselected. Do not change the preselection. Select Next.
   Licenses	Accept the license agreements. Then, select Next.
   Shared Directory	Default installation paths are shown for IBM Installation Manager and the shared resources directory. You can change the paths. Select Next.
   Location	A default installation path is shown for the add-ons package. You can change this path. Select Change to 32-bit architecture. Then, select Next.
   Translations	Ignore the language selection. All supported languages are always installed. Select Next.
   Features	The add-ons package is preselected. Select Next.
   Custom panels	Select your license type. Then, select Next.
   Summary	You can verify your specifications. Then, select Install. If you want to generate only a response file for a silent installation of the add-ons package, select Generate an Installation Response File and follow the instructions on the console. Then, select Cancel to cancel the installation

   Notes:

   • An installation path can contain ASCII characters only. Other characters, such as native-language characters, are not supported.
   • An installation path must not contain any blanks. In addition, it must not exist.
5. After the installation, verify that the installation was successful. Then, select Finish.
   If an error occurs, view the log file.