addService

Purpose

Use this command to add one or more services to an FTM SWIFT service list. If the list you specify does not exist, it is created.

The creation of a new service list or changes to an existing list do not become effective for an SAG until its configuration is approved and deployed as described in Approving and deploying SAG configuration data. At that time, all message partners to which the service list is assigned are automatically updated to reflect the changes.

If a service list is shared among several SAGs, you must deploy all those SAGs. Which SAGs are affected can be determined by issuing the listServiceLists command, which is described in listServiceLists.

Required access rights:	See Table 4
Predefined roles that provide required access rights:	See Table 2
Issue for OU:	DNFSYSOU
Issue to service:	DNFSAGCFG

Format

Parameters

-sln servlist_name

Name of the service list. This name cannot exceed 30 characters and can contain only the following characters:

Uppercase letters (A - Z)
Lowercase letter (a - z)
Numerals (0 - 9)
Underscore (_)

-serv service

Service to be added to the list. Each list can contain up to 10 services.

Examples

The following command, entered on a single line, adds three services to the service list with the name servlist1:

INST1.DNFSYSOU.DNFSAGCFG>as -sln  servlist1
                            -serv swift.fin!p
                            -serv swift.rma
                            -serv service3