To alter an AOM CTRACE without
using an external output writer,
perform the steps shown in the following example. This example will
trace for JOBNAME AOMV2 and for ASID 3F. It is possible to selectively
trace up to 16 JOBNAMES and 16 ASIDs.
- Issue the operator
TRACE command and reply to the resulting message.
TRACE CT,ON,COMP=SYSAOM
*05 ITT006A SPECIFY OPERAND(S) FOR TRACE CT COMMAND.
R 5,JOBNAME=(AOMV2),ASID=(3F),END
- Display the
trace information for SYSAOM.
DISPLAY TRACE,COMP=SYSAOM
You
should see a response similar to this example:
RESPONSE=SYSTEM1
IEE843I 16.46.07 TRACE DISPLAY 810
SYSTEM STATUS INFORMATION
ST=(ON,0001M,00001M) AS=ON BR=OFF EX=ON MO=OFF MT=(ON,999K)
COMPONENT MODE BUFFER HEAD SUBS
--------------------------------------------------------------
SYSAOM ON
ASIDS 003F
JOBNAMES AOMV2
OPTIONS YES
WRITER *NONE*
- Restore AOM CTRACE to
its normal trace level using the TRACE command.
TRACE CT,OFF,COMP=SYSAOM
- If the input
source to IPCS is to be a dump, issue the following
command:
F DEVMAN,DUMP
- Issue the IPCS CTRACE
COMP(SYSAOM) subcommand and set the input
source to either the dump created in the step above or to active.
CTRACE COMP(SYSAOM) FULL LOCAL