Use the SET command to change or reset a previously defined condition
code. You can end all processing by setting MAXCC or LASTCC to 16.
The syntax of the SET command is:
Command |
Parameters |
---|
SET |
{MAXCC|LASTCC}=number |
|
|
where:
- SET
- States that a condition code value is to be set. A SET command
that follows a THEN or ELSE that is not run does not alter LASTCC
or MAXCC.
- MAXCC
- Requires that the value to be reset is the maximum condition code
set by a previous functional command. Setting MAXCC does not affect
LASTCC.
- LASTCC
- Specifies that the value to be reset is the
condition code set by the immediately preceding functional command.
- number
- Is the value to be assigned to MAXCC or LASTCC. The maximum value
is 16; a greater value is reduced to 16. If the value of LASTCC is
greater than MAXCC, MAXCC is set equal to the larger value.