Explanation: volser is a required
positional parameter specifying the serial number of (1) a non-SMS-managed
volume to be added to DFSMShsm control, (2) a volume currently managed
or owned by DFSMShsm, and (3) a volume previously defined for aggregate
recovery.
For volser, substitute the serial number of the volume
being added or changed.
Defaults: None.
Note: - Because volser is a required positional parameter, you
must specify it immediately after the command name.
- When an attempt is made to add an SMS-managed volume using the
ADDVOL command, the command is rejected and a message is issued.
- A volume previously defined to aggregate recovery with the L0VOLS
parameter of the DEFINE ARPOOL command can be subsequently added to
DFSMShsm only as a PRIMARY volume.
- A volume previously defined to aggregate recovery with the ML1VOLS
parameter of the DEFINE ARPOOL command can be subsequently added to
DFSMShsm only as an ML1 volume.
- If a specific scratch volume managed by RMM is added to DFSMShsm,
RMM rejects it with message EDG4036I when DFSMShsm attempts to use
it.