Find information about preparing the system for operation
after removing and replacing an internal RDX docking station (FC EUA3)
USB cable that failed in the system or as part of another service procedure.
To complete this procedure, you must have replaced an internal RDX docking station (FC EUA3) USB cable in the system. For
instructions, see Removing and replacing an internal RDX docking station (FC EUA3) USB cable in the system with the power turned off.
To prepare the system for operation, complete the following
steps:
- Ensure
that you have the electrostatic discharge (ESD) wrist strap on and
that the ESD clip is connected to an unpainted metal surface. If not,
do so now.
- Install the 8286-41A side cover. For instructions, see Installing the side cover on a
stand-alone 8286-41A system with an internal RDX docking station.
- Install the service access cover. For instructions, see
Installing the service access cover.
- Reconnect
the power cords to the system. For instructions, see Connecting
the power cords.
- Start the
system or logical partition. For instructions, see Starting
a system or logical partition.
- Verify the installed part.
- If you replaced the part because of a service action, verify the
installed part. For instructions, see Verifying a repair.
- If you installed the part for any other reason, verify the installed
part. For instructions, see Verifying
the installed part.
