You can use the IBM® Systems Director Management Console (SDMC) to perform many service
actions, including the removal of a field-replaceable unit (FRU) or
part.
To remove a part in a system or expansion unit that is
managed by an SDMC,
complete the following steps:
- In the Power Systems Resources area, select the managed
system from which you are removing a part.
- From the Actions menu, expand .
- On the Remove FRU page, select the enclosure from which
you want to remove the part from the Installed Enclosures list.
- Select the type of the part that you are removing, and
click Next.
- Select the location of the part that you are removing,
and click Add.
- After the part is listed in the Pending Actions section,
click Launch Procedure and follow the instructions
to remove the part.
Note: The SDMC might open external
instructions for removing the part. If so, follow those instructions
to remove the part.
Subscribe to this information