POWER7 information

Cabling the server and setting up the console

Your console, monitor, or interface choices are guided by whether you create logical partitions or virtual servers, which operating system you install in your primary partition or virtual server, and whether you install a Virtual I/O Server in one of your logical partitions or virtual servers.

Note: If you ordered your system or expansion unit preinstalled into a rack, you must remove the shipping bracket that is on the left side of the rear of the system or expansion unit before you cable it.

Choose one of the applicable console, interface, or terminal in the following table.

Table 1. Available console types
Console type	Operating system	Logical partitions	Cable required	Cabling and setup instructions
ASCII terminal	AIX®, Linux, or VIOS	Yes for VIOS, no for AIX andLinux	Serial cable equipped with a null modem	Cabling the server with an ASCII terminal
Hardware Management Console	AIX, IBM® i, Linux, or VIOS	Yes	Ethernet (or cross-over cable)	Cabling the server to the Hardware Management Console
Operations Console	IBM i	Yes Use your Operations Console to manage existing IBM i partitions.	Ethernet cable for LAN connection	Cabling the server and accessing Operations Console
Integrated Virtualization Manager for VIOS	AIX, Linux, or IBM i	Yes	Serial cable	Cabling the server and accessing the Integrated Virtualization Manager

Send feedback | Rate this page

Last updated: Thu, October 10, 2013