FSPSP07

The time of day has been reset to the default value.

1. To set the time of day, see the systems operations guide.
2. If the problem persists, perform the following steps:
   1. Power off the system. See Powering on and powering off the system .
   2. To determine the action to perform, use the following table.

      System	Action
      8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, 8205-E6D, 8231-E2B, 8231-E1C, 8231-E1D, 8231-E2C, 8231-E2D, 8233-E8B, 8236-E8C, or 8268-E1D	Replace the time-of-day battery at location Un-P1-E1. See System FRU locations.
      8248-L4T, 8408-E8D, 8412-EAD, 9109-RMD, 9117-MMB, 9117-MMC, 9117-MMD, 9179-MHB, 9179-MHC, or 9179-MHD	Replace the time-of-day battery at location Un-P1-C1-E1. See System FRU locations.
      9119-FHB	Replace the time-of-day battery. To determine which battery to replace, use the last byte in word 3 of the primary SRC. If the last byte is a 10, replace the system controller card 0 time-of-day battery. If the last byte is a 20, replace the system controller card 1 time-of-day battery.
      9125-F2C	Replace the time-of-day battery. To determine which battery to replace, use the location code specified with the SRC. If a location code is not available, look at the amber battery LEDs on the front of the DCCAs. Replace the battery next to the amber LED that is lit.

3. To determine the action to perform, use the following table.

   System:	Action:
   8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, 8205-E6D, 8231-E2B, 8231-E1C, 8231-E1D, 8231-E2C, 8231-E2D, 8248-L4T, 8268-E1D, 8408-E8D, 9109-RMD, 9119-FHB, or 9125-F2C	Power on the system to the hypervisor standby. Note: Slow boot is not supported.
   8233-E8B or 8236-E8C	Determine the level of firmware the system is running. Is system firmware AL710_xxx installed? Yes: Perform a slow boot. See Performing a slow boot. No: Power on the system to the hypervisor standby.
   8412-EAD, 9117-MMB, 9117-MMC, 9117-MMD, 9179-MHB, 9179-MHC, or 9179-MHD	Determine the level of firmware the system is running. Is system firmware AM710_xxx installed? Yes: Perform a slow boot. See Performing a slow boot. No: Power on the system to the hypervisor standby.

   This ends the procedure.