FSPSP02

This procedure is for boot failures that terminate very early in the boot process.

1. Is the system a 9119-FHB or a 9125-F2C?
   • No: Continue with the next step.
   • Yes: Save any error log and dump data and contact your next level of support for assistance. This ends the procedure.
2. Push the white power button to reset the system and start it on the other side of the platform Licensed Internal Code.
   Note: The white power button will only reset the system and attempt to reach standby.
3. Did an SRC occur after starting the system on the other side?
   • No: Verify that the system's firmware is at the latest level. Update the system's firmware on the failing side if necessary. Perform LICCODE. This ends the procedure.
   • Yes: Continue with the next step.
4. Is the SRC the same SRC that brought you to this procedure?
   • No: Return to Start of call to service this new SRC. This ends the procedure.
   • Yes: Perform the action indicated in the table below for your system.

     System:	Action:
     8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, 8205-E6D, 8231-E2B, 8231-E1C, 8231-E1D, 8231-E2C, 8231-E2D, 8233-E8B, 8236-E8C, 8268-E1D	Replace the system backplane (Un-P1). Refer to System FRU locations to locate the correct system location of the part you are replacing. If the problem is not resolved, contact your next level of support. This ends the procedure.
     8248-L4T, 8408-E8D, 9109-RMD	Replace the service processor at location Un-P1-C1. If the problem persists, replace the system midplane at location Un-P1. This ends the procedure.
     8412-EAD, 9117-MMB, 9117-MMC, 9117-MMD, 9179-MHB, 9179-MHC, or 9179-MHD	Replace the service processor. If the problem persists, replace the system midplane at location Un-P1. This ends the procedure.