Isolates a failure that is detected by the workstation
adapter, and is used when no display is available with which to perform
on-line problem analysis.
The workstation adapter detected a problem while communicating
with the workstation that is used as the primary console.
Note: If you are using a PC, you must install an emulation program.
Read and observe all safety procedures before servicing the system
and while performing the procedure below.
Attention: Unless instructed otherwise, always power off
the system or expansion unit where the FRU is located (see
Powering on and powering off
the system ) before removing, exchanging, or installing
a field-replaceable unit (FRU).
DANGER
When working on or around the system,
observe the following precautions:
Electrical voltage and current
from power, telephone, and communication cables are hazardous. To
avoid a shock hazard:
- Connect power to this unit only with the IBM provided
power cord. Do not use the IBM provided power
cord for any other product.
- Do not open or service any power supply assembly.
- Do not connect or disconnect any cables or perform installation,
maintenance, or reconfiguration of this product during an electrical
storm.
- The product might be equipped with multiple power cords. To remove
all hazardous voltages, disconnect all power cords.
- Connect all power cords to a properly wired and grounded electrical
outlet. Ensure that the outlet supplies proper voltage and phase
rotation according to the system rating plate.
- Connect any equipment that will be attached to this product to
properly wired outlets.
- When possible, use one hand only to connect or disconnect signal
cables.
- Never turn on any equipment when there is evidence of fire, water,
or structural damage.
- Disconnect the attached power cords, telecommunications systems,
networks, and modems before you open the device covers, unless instructed
otherwise in the installation and configuration procedures.
- Connect and disconnect cables as described in the following procedures
when installing, moving, or opening covers on this product or attached
devices.
To Disconnect:
- Turn off everything (unless instructed otherwise).
- Remove the power cords from the outlets.
- Remove the signal cables from the connectors.
- Remove all cables from the devices.
To Connect:
- Turn off everything (unless instructed otherwise).
- Attach all cables to the devices.
- Attach the signal cables to the connectors.
- Attach the power cords to the outlets.
- Turn on the devices.
(D005)
Subscribe to this information