Subscribe to this information
POWER7 information
SIRGCFG
An invalid configuration was detected on an HSL/RIO loop during the IPL.
The four rightmost characters of word 4 in the reference code represent the Program Return Code (PRC), which describes the problem detected. The four leftmost digits of word 7 represent the loop number in hexadecimal format. Convert the loop number to decimal format before comparing it to loop numbers shown in serviceable event views and service tools.
To determine the problem, find the PRC in the table below.
Note: The FRU description in the serviceable
event view might already contain a message that identifies the problem.
| PRC | Problem identified | Corrective action |
|---|---|---|
| xxxx 0008 | System serial number not set | Set the serial number on the system unit. See Accessing the Advanced System Management Interface. If the problem persists contact your next level of support. |
| xxxx 3200 | Clustered systems on loop with SPD migrated expansion unit | Migration expansion units are not supported; remove them. |
| xxxx 3201 | Clustered systems on multiple HSL/RIO loops | Ensure all clustered systems are on the same HSL/RIO loop. |
| xxxx 3202 | Multiple SPD migrated expansion units detected | Migration expansion units are not supported; remove them. |
| xxxx 3207 | SPD migrated expansion unit not on first HSL/RIO loop | Migration expansion units are not supported; remove them. |
| xxxx 3212 | NIC/RIO controller level does not support OptiConnect | The NIC/RIO controller hardware component does not support HSL OptiConnect. The FRU that contains the NIC/RIO controller component must be upgraded to a level that supports HSL OptiConnect. Examine the service action log (SAL) of the system on this loop for the same error. The SAL will indicate the correct FRU to replace. Use the service tools and information for that system to correct the problem and close the problem on this system. |
| xxxx 3218 | An HSL or RIO loop was detected on the system, but none of the resources on the loop are assigned to the logical partition. HSL and RIO loops are not supported in this version of the operating system. | No service action is required. This PRC is logged for information only. |
| xxxx 3219 | An HSL or RIO loop was detected on the system and some of the resources on the loop are assigned to the logical partition. HSL and RIO loops are not supported in this version of the operating system. | The logical partition cannot power on with some of the resources on the HSL or RIO loop assigned to the logical partition. Assign the resources on the HSL or RIO loop to a different logical partition. |
This ends the procedure.
