Display panel

Use this procedure to service the display panel.

1. The component will be serviced non-concurrently. Power should be removed from the unit. If this unit is powered on, power it off now. When the unit is completely powered off, disconnect the AC input source by removing the power cord from the unit. Do not apply power to the unit until directed to do so in this procedure.

2. Remove the front bezel

   Open the front rack door. Simultaneously press in both bezel-release tabs (A). Pivoting the bezel from the bottom, swing the top of the bezel out. Pull the bottom of the bezel up, and then away from the subsystem chassis (B). This action releases the two tabs (C) located on the bottom of the bezel. Put the bezel in a safe place.

3. Remove the display panel

   Remove the display panel by pulling out on the two side handles (A) and sliding the display panel partially out of the frame. Disconnect the cable that is attached to the rear of the display panel. Remove the display panel by grasping its edges and slowly pulling it out of the enclosure.

4. Install the display panel

   Slide the new display panel assembly partially into the frame by pushing in on the handles (A) on each side of the assembly. Connect the end of the display panel cable to the rear of the display panel. Install the display panel by pushing in on the handles (A) on each side of the assembly and sliding it into the enclosure.

5. Install the front bezel

   Open the front rack door. Insert the two tabs (C) located on the bottom edge of the bezel into their locking slots (B), located on the chassis. Pivot the front bezel up toward the top of the chassis. Align the release tabs (A) to the matching slots located on the front of the subsystem chassis. Gently push the release tabs into the slots until the bezel seats against the front of the subsystem. If the subsystem is in the service position, put the subsystem back into the operating position. Reconnect the power source. Close the rack door.