Reconnect the SMP processor cable to a system unit

You might need to reconnect this cable after adding or removing memory or processors. Use the procedure in this section to accomplish this task.

1. Perform prerequisite tasks as described in Before you begin.
2. Stop all system units. Refer to Stop the system or logical partition.
3. If necessary, open the front rack door.
4. Disconnect the power source from the system by unplugging the system.
   Note: This system can be equipped with a second power supply. Before continuing with this procedure, ensure that the power source to the system has been completely disconnected.
5. If necessary, remove the left edge of the trim kit on the system rack.
6. Lift the latch handle B to the open position, as shown in the following figure.
   
7. Align the guide pins with the connector on the system unit.
8. Carefully push the connector A into the system unit connection.
9. Push the latch handle down to seat the pins.
10. Secure the plastic fastener C.
11. Replace the left edge of the trim kit.
12. Install the front cover on the model 9116-561 or 570.
13. Close the front rack door.