Installing the 5095, 0595, or 7311-D20 expansion unit into a rack

You might need to install an expansion unit into the rack. Use the procedure in this section to perform this task.

This procedure assumes that you are installing the model 5095, 0595, or 7311-D20 expansion unit into an existing rack. If the rack is not installed, go to the instructions for Install the rack. and then return to this procedure for instructions on installing the system unit into the rack.

Note: This procedure applies only to the models that are designed to be mounted in a rack. Do not attempt to install a stand-alone model in a rack.

To install the 5095, 0595, or 7311-D20 into a rack, complete the following steps:

Read the Rack Safety Notices.
Unpack the template and rack hardware.

Figure 1. Unpacking the rack template and hardware.
Complete a parts inventory (See Completing a parts inventory).
Determine where you will locate the expansion unit in the rack. See Locate in rack.
Mark the location. See Marking the location using a rack-mounting template. If you do not have the rack-mounting template, see Marking the location without a rack-mounting template.