Place the model 505 in the operating position

You might need to place a system into the operating position to make the system available for use. Use the procedure in this section to perform this task.

Tip: Some of the figures in these procedures might not look exactly like the system unit that you have. However, the steps to perform the task are the same.

To place the system unit into the operating position, follow these steps:

Lift the system unit, and position over the rails.
CAUTION:
This unit weighs approximately 17 kg (37 pounds). Be sure you can safely support this weight when placing the system unit from the rack.
Simultaneously release the safety latches, located near the middle of each side of the system, and push the system unit into the rack. Both rack latches should lock into position.
Note: Ensure that the cables at the rear of the system unit do not catch or bind as you push the unit back into the rack.
Replace and tighten the two screws A that secure the system unit to the rack as shown in the following figure.
Figure 1. Replace the thumbscrews
Connect the cables and cords.
Replace the cable management arm.
Close the front rack door.