Using HyperTerminal through the serial port

Set the parameters for the power-on sequence function by using a serial port (HyperTerminal interface).

About this task

To set the parameters for the power-on sequence function by using a serial port (HyperTerminal interface), complete the following steps:

Procedure

  1. Make sure that the serial port configuration is 115200, 8-N-1-None.
  2. Log-in as ADMIN/1001.
  3. On the IBM PDU Configuration Utility main meu, type 8 to select Set PDU Location and Outlet Information.
  4. Ttype the GlobalDelayTimer value.
  5. On the main menu, type the IndividualDelayTimer values for each outlet.