arcconf commands

Learn about the arcconf commands. They are for SATA drives and drive on modules (DOMs) that are directly connected to the system backplane without using a PCIe adapter.

To list the logical drives and device configurations, use the following arcconf command.

arcconf getconfig 1

Note the Channel and Device numbers of the desired drive. Also note the serial number of the drive. In the following example, the channel number is 0 and the device number is 11.

Reported Channel,Device(T:L) : 0,11(11:0)

arcconf identify 1 device 0 2

Take the drive off line. Run the following arcconf setstate command that uses the Channel and Device numbers from the arcconf getconfig command:

arcconf setstate 1 device 0 11 ddd