Placing an 8335-GCA or 8335-GTA system into the operating position
Learn how to place an IBM® Power® System S822LC (8335-GCA and 8335-GTA) system into the operating position.
About this task
Slide rails
Use this procedure when your system is installed using slide rails.
Before you begin
Procedure
- Align the system unit on to the rails and push the system unit back into the rack until both
release latches lock into position.
Figure 1. Placing the system into the operating position
Fixed rails
Use this procedure when your system is installed using fixed rails.
Before you begin
CAUTION:
This system requires two people to replace the system into the rack. Do not
begin this procedure unless physical assistance is available to replace the system into the
rack.
Note: When placing the system into the operating position, it is essential that all stability plates
are firmly installed to prevent the rack from toppling. Ensure that only one system unit is replaced
at a time.
Procedure
- Position one person on the left side of the system and one person on the right side of the system.
- Lift the system.
- Move the system into position over the front of the fixed rack rails.
- Carefully lower the system until the rear of the system rests on the rails.
- Push the system all the way into the rack.
- Using your labels, reconnect the cables at the rear of the system unit.
- At the front, replace the screws on either side of the system that secure the system to the rack.
