Preparing the system for operation after removing and replacing a power riser

To prepare the system for operation after removing and replacing a power riser, complete the steps in this procedure.

1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Replace the service access cover. For instructions, see Installing the service access cover.
3. Place the system into the operating position. For instructions, see Placing the system into the operating position.
   (L012)

   

   CAUTION:

   Pinch hazard. (L012)
4. Install both of the power supplies into the system. For instructions, see Installing the power supplies.
5. Reconnect the power cords to the system. For instructions, see Connecting the power cords.
6. If applicable, close the rack door at the rear of the system.
7. Start the system. For instructions, see Starting a system.
8. Replace the front cover. For instructions, see Replacing the front cover.
9. Verify the installed part. See Verifying a repair in the 8335-GCA or 8335-GTA.
10. If applicable, close the rack front door.