Connecting the power cables to the system

You might need to connect power cables to the system. Use this procedure to perform this task.

1. Remove the power supply shipping bracket (if present). Ensure that the power supplies have been fully re-seated, as shown in Figure 1.
   Figure 1. Removal of shipping bracket

   
2. While facing the rear of the system unit, route the system power cord through the cable retention bracket, as shown in Figure 2.
   Note: You may need to pull the power supply out slightly to route the cable though the retention bracket. Once you have routed the cable through the retention bracket, re-seat the power supply.
   Figure 2. Power cord attachment and routing

   
3. Plug the power cord into the power supply.
   Note: This system is equipped with two power supplies. If you want to configure the system with redundant power supplies, you must connect each power cable to its own power source.
4. Plug the system power cords and the power cords for any other attached devices into the alternating current (ac) power source.
   Note: Confirm that the system is in standby mode. The green power status indicator on the front control panel is flashing slowly, and the dc out indicator lights on the power supplies are flashing. If none of the indicators are flashing, check the power cord connections. For detailed information, see Common system attention LEDs and system reference codes.