NetView and System Automation Level 2 support blog
JohnArnesen 110000NVJV Visits (2823)
This is John Arnesen with a NetView and System Automation Level 2 support blog.
Are you running NetView v6r1 and seeing issues with MVS Message Automation? Issues like MVS messages not getting automated on, or what looks like hangs in message automation processing? Please note this issue can be seen in NetView, System Automation or GDPS MVS Message Processing.
This is most likely caused by a Canzlog problem. Even if you are not using Canzlog, it is involved with Message Automation in v6r1. NetView message automation was changed in the v6r1 release as follows: 1) From MVS, the message flows across the NEtView SSI to Canzlog. 2) The message is then sent across the CNMCSSIR task to the NetView Automation Table for processing.
There is a problem with Canzlog where the message is not sent to the NetView Automation Table so it is not automated on.
The following HIPER apars are available/being worked on:
1) OA40414/UA67430: This ptf is currently avaialble
2) OA40854: This is currently being worked on
PLEASE NOTE THE FOLLOWING:
If you believe you are seeing MVS Message Automation problems in NetView v6r1, please open a pmr with NetView level 2 defect support and we will request some documentation to verify that the automation problem is Canzlog related.