Topic
  • 3 replies
  • Latest Post - ‏2013-12-03T09:58:02Z by sampathkvl
sampathkvl
sampathkvl
2 Posts

Pinned topic How to trigger Baseline ?

‏2013-11-20T06:23:40Z |

Hello

Wrote couple of TEM baselines. Want to activate these baselines from third party products. Want to check whether there is any way to perform these activities.

Pls share me customer references incase this is acheivable.

 

regards

sampath

  • Tim.Rice
    Tim.Rice
    11 Posts

    Re: How to trigger Baseline ?

    ‏2013-11-26T19:23:13Z  

    I believe you would need to look into using the REST API's to perform actions in IEM/TEM/BigFix from outside the products Console.

    There are several discussions in this forum that discuss submitting Actions via the Rest API's.

    Documentation on the REST APIs : https://www.ibm.com/developerworks/community/wikis/home?lang=en#/wiki/Tivoli%20Endpoint%20Manager/page/REST%20API

  • liuhoting
    liuhoting
    5 Posts

    Re: How to trigger Baseline ?

    ‏2013-11-27T08:14:29Z  
    • Tim.Rice
    • ‏2013-11-26T19:23:13Z

    I believe you would need to look into using the REST API's to perform actions in IEM/TEM/BigFix from outside the products Console.

    There are several discussions in this forum that discuss submitting Actions via the Rest API's.

    Documentation on the REST APIs : https://www.ibm.com/developerworks/community/wikis/home?lang=en#/wiki/Tivoli%20Endpoint%20Manager/page/REST%20API

    Also don't forget that everything's a fixlet in Bigfix, so even though the REST API stuff talks a lot about taking an action on fixlets, I think you can use the same principle to take an action on baselines. 

    See this post here:

    https://www.ibm.com/developerworks/community/forums/html/topic?id=f9994bb6-83f7-4229-91cb-346da3e0b212

     

     

  • sampathkvl
    sampathkvl
    2 Posts

    Re: How to trigger Baseline ?

    ‏2013-12-03T09:58:02Z  
    • liuhoting
    • ‏2013-11-27T08:14:29Z

    Also don't forget that everything's a fixlet in Bigfix, so even though the REST API stuff talks a lot about taking an action on fixlets, I think you can use the same principle to take an action on baselines. 

    See this post here:

    https://www.ibm.com/developerworks/community/forums/html/topic?id=f9994bb6-83f7-4229-91cb-346da3e0b212

     

     

    Hello
     

    Thank you very much for reply.  Let me take a very simple point.

    a. There are exisiting fixlets at TEMs.

    b. Want to trigger fixlets from third party products using TEM baselines.

    My understanding is that using REST API calls it is possible to trigger TEM baselines. Would anyone share what are the limitation performing this solution method ?

    last but not least do this solution method was been performed for any customer ?

     

    thanks in advance.