Dual VIO presenting a single dual-pathed vscsi 100GB boot volume to LPAR
PowerLinux Toolkit 5.3
Attempting to install RHEL 6.3 via the Toolkit ... RHEL ISO presented via nfs off another Linux host
Toolkit ISO presented to the lpar via a VM Library and Virtual Optical Device on 1 of the 2 VIO
Toolkit boots ... gets into Wizard mode, pulled up on browser to continue the config ... 100GB volume is seen as mpatha (sda, sdb) ... all good so far
Work through the wizard and configure ... to the point where it will install Linux ... click Next
Distro installation will begin on next boot from hard disk. Rebooting in 5 seconds...
lpar Reboots then cannot find any boot device to boot from to continue the install or RHEL from ... sorry the the verbosity ... but Now What?
Manually working SMS and it still cannot discover any bootable device ... ?