I have a v3700 (system version 188.8.131.52) set up so that management IP is on port 1 and iSCSI is configured to another network on port 2 only. However, I'm not able to ping any IP address in the same iSCSI subnet from v3700 SSH command line - the Destination Net Unreachable message comes from a router that is behind the management port.
I have double-checked that the subnet mask on iSCSI is correct.
Why does v3700 try to communicate via default gateway on management port 1 if the device is directly connected to iSCSI subnet on port 2? Command lsroute shows an empty IPv4 routing table.
I've read Example iSCSI configurations and my configuration should be similar to Figure 2 except there is only management interface in Port 1 in each node and only iSCSI in Port 2 in each node.
With best regards,