Hi,
I've observed Client partition Id as 0x00000000 on VIOS for few of the lpars. Is there any way to make sure that partition Id get displayed in the 'lsmap -all' output.
Thanks,
Chinni
Hi,
I've observed Client partition Id as 0x00000000 on VIOS for few of the lpars. Is there any way to make sure that partition Id get displayed in the 'lsmap -all' output.
Thanks,
Chinni
- Wouter Liefting
- 2014-07-07T08:02:25Z
Start the partition. The 0x0 means that no partition is, or has been connected to this vSCSI server adapter.
No disks have been attached to the lpar. I tried to activate the LPAR using
chsysstate -r lpar -m <managedsystem> -o on -f <profilename> -n <lparname>
But, still I could able to see 0x0 only. Am I missing anything?
thanks,
Chinni
- Wouter Liefting
- 2014-07-07T08:02:25Z
Start the partition. The 0x0 means that no partition is, or has been connected to this vSCSI server adapter.
No disks have been attached to the lpar. I tried to activate the LPAR using
chsysstate -r lpar -m <managedsystem> -o on -f <profilename> -n <lparname>
But, still I could able to see 0x0 only. Am I missing anything?
thanks,
Chinni