Topic
1 reply Latest Post - ‏2013-05-29T16:20:06Z by dj.muysson
AmitP
AmitP
1 Post
ACCEPTED ANSWER

Pinned topic SNMP setting via ASU

‏2013-05-20T17:06:57Z |

Hello,

I'm looking to set the following parameters via ASU utility on the IMM2.

Could not find any properties to change by executing "ASU showvalues" or "ASU show all"

Setting I want to change are:

1. Allow Any Host to query MIB

2. Enable - Accept IPv4 Hosts.

 

I'm using latest uEFI and IMM firmware.

Best Regards

Amit Peled

Updated on 2013-05-20T17:07:12Z at 2013-05-20T17:07:12Z by AmitP
  • dj.muysson
    dj.muysson
    9 Posts
    ACCEPTED ANSWER

    Re: SNMP setting via ASU

    ‏2013-05-29T16:20:06Z  in response to AmitP

    If you try using the ASU save command to dump the IMM config to a file, does it contain the setting your looking for? Sometimes not all values are shown using the show all, show defaults, or show values command.