I am trying to run this:
but all I am getting is:
"Could not load the resource library %TEMP%\\db2istring_v101.dllThe specified module could not be found."
Where %TEMP% are the actual contents of the TEMP variable. Note the double "\\" after the contents of the TEMP variable... The actual path displayed is "...\AppData\Local\Temp\2\\db2istring_v101.dll".
If I check there, the dll is present.
Pinned topic Running db2prereqcheck for DB2 10.1.2 on Windows 2008 R2
Answered question This question has been answered.
Unanswered question This question has not been answered yet.
Updated on 2013-04-03T13:37:13Z at 2013-04-03T13:37:13Z by SystemAdmin
nivanov1 100000H9H7231 Posts
Re: Running db2prereqcheck for DB2 10.1.2 on Windows 2008 R22013-04-02T23:03:44ZThis is the accepted answer. This is the accepted answer.Does the value of the %TEMP% variable, as showing in the output of the "set" command, contain the trailing backslash?
SystemAdmin 110000D4XK17917 Posts
Re: Running db2prereqcheck for DB2 10.1.2 on Windows 2008 R22013-04-03T13:37:13ZThis is the accepted answer. This is the accepted answer.
- nivanov1 100000H9H7