Topic
  • 3 replies
  • Latest Post - ‏2013-03-29T18:53:40Z by PeterJO
PeterJO
PeterJO
33 Posts

Pinned topic Are there any templates available for RTC???

‏2013-03-28T17:52:50Z |
I am trying to pprint out a list of open defects and test cases etc that are associated to those defects, but I have no idea where to even start. I can easily generate templates for doors, that was pretty straight-forward. But I needed proffesional help for RQM and now I am at a complete loss as far as RTC is concerned. If I had a few example templates I could probably figure stuff out.

Any help would be greatly appreciated.

Peter Osborne
Updated on 2013-03-29T18:53:40Z at 2013-03-29T18:53:40Z by PeterJO
  • Dragos.Cojocari
    Dragos.Cojocari
    1617 Posts

    Re: Are there any templates available for RTC???

    ‏2013-03-28T19:39:07Z  
    Hey Peter,

    have you seen this: CLM Traceability with RPE ?

    Regards,
    Dragos

    RPE Actual
  • PeterJO
    PeterJO
    33 Posts

    Re: Are there any templates available for RTC???

    ‏2013-03-28T20:10:24Z  
    Hey Peter,

    have you seen this: CLM Traceability with RPE ?

    Regards,
    Dragos

    RPE Actual
    I had not. There is so much info scattered it is hard to find. The proverbial needle in the haystack or forest for the trees...whichever one works. I will have to look into this article tomorrow, my brain is fried. reporting through doors is so much easier.
  • PeterJO
    PeterJO
    33 Posts

    Re: Are there any templates available for RTC???

    ‏2013-03-29T18:53:40Z  
    • PeterJO
    • ‏2013-03-28T20:10:24Z
    I had not. There is so much info scattered it is hard to find. The proverbial needle in the haystack or forest for the trees...whichever one works. I will have to look into this article tomorrow, my brain is fried. reporting through doors is so much easier.
    Ok there is quite a bit of info here. Is there a dumbed down version. Like a step by step instruction for dummies?