Hi!
I have an bladecenter s , mt 8886
I receive this error:
"An error on I/O Module 3 was detected"
"An error on I/O Module 4 was detected"
and
all the blades server lost connection to both storage modules
(blade server can not see hdd from storage)
Any solutions ?
Thanks!
Topic
-
Re: An error on i/o module 3,4 was detected
2013-04-03T09:32:42ZThis is the accepted answer. This is the accepted answer.
- SystemAdmin
- 2013-03-25T11:41:17Z
Check RSSM's CLI - use command alert -get
unable to communicate with controller -
Re: An error on i/o module 3,4 was detected
2013-04-03T13:48:56ZThis is the accepted answer. This is the accepted answer.
- SystemAdmin
- 2013-04-03T09:32:42Z
I try but I get nessage:
unable to communicate with controller
telnet/ssh to the AMM
ifconfig -T switch[3]
ifconfig -T switch[4]
telnet to one of the RAID controller modules (RAID side)
list controller
If the telnet to the RAID controller module fails, attach the AMM Service Data.
Thanks.
Stay tuned for the new Redbook "Implementing the BladeCenter S Chassis, 2nd Edition". Updated, improved, and ready to help you deploy your IBM BladeCenter S. -
Re: An error on i/o module 3,4 was detected
2013-04-19T05:54:42ZThis is the accepted answer. This is the accepted answer.
- SystemAdmin
- 2013-04-03T13:48:56Z
Can you run these commands and past the output?
telnet/ssh to the AMM
ifconfig -T switch[3]
ifconfig -T switch[4]
telnet to one of the RAID controller modules (RAID side)
list controller
If the telnet to the RAID controller module fails, attach the AMM Service Data.
Thanks.
Stay tuned for the new Redbook "Implementing the BladeCenter S Chassis, 2nd Edition". Updated, improved, and ready to help you deploy your IBM BladeCenter S.Hi!
I run :
ifconfig -T switch[3]
ifconfig -T switch[4]and it is ok
but If I run list controller with telnet I get the message:
"unable to communicate with controller"
I send you in atachament AMM service Data
Thanks!
Thanks!
Attachments