Topic
3 replies Latest Post - ‏2013-03-22T09:50:07Z by Baldroega
Baldroega
Baldroega
6 Posts
ACCEPTED ANSWER

Pinned topic After updating Fw for DS3524 Dual controller, started getting Error..

‏2013-03-20T15:03:40Z |
Hi,

After a suposed successfull update of firmware on a DS3524 i keep getting the following error from 5 to 5 minutes:

Date/Time: 20-03-2013 14:57:39
Sequence number: 8081
Event type: 4011
Description: Logical Drive not on preferred path due to ADT/RDAC failover
Event specific codes: 0/0/0
Event category: Error
Component type: Controller
Component location: Enclosure 0, Slot A
Logged by: Controller in slot A

Raw data:
4d 45 4c 48 03 00 00 00 91 1f 00 00 00 00 00 00
11 40 18 01 63 ce 49 51 00 00 00 00 00 00 00 00
00 00 00 00 01 00 00 00 22 00 00 00 22 00 00 00
08 00 00 00 00 00 00 00 01 00 00 00 01 00 00 00
0a 00 00 00 01 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
01 00 00 00 00 00 00 00 00 00 00 00
The SAN is connected to a Bladecenter System H on two 8GB's switches from Brocade.
Dont know why i get this error, can someone help me?

sincerely,
AM
Updated on 2013-03-22T09:50:07Z at 2013-03-22T09:50:07Z by Baldroega
  • Baldroega
    Baldroega
    6 Posts
    ACCEPTED ANSWER

    Re: After updating Fw for DS3524 Dual controller, started getting Error..

    ‏2013-03-20T15:13:32Z  in response to Baldroega
    I think i know what is causing this error:

    I have several logical drives that are not working on their prefered ( owner) controller.

    Shouldnt this have only a warning instead of an error?
    The previous version of the FW didnt reported this error ( it is normal?

    Thanks for the attention.

    Sincerely,
    AM
    • Baldroega
      Baldroega
      6 Posts
      ACCEPTED ANSWER

      Re: After updating Fw for DS3524 Dual controller, started getting Error..

      ‏2013-03-20T16:02:04Z  in response to Baldroega
      Another Update:

      These are some logical drives that are preferred to Controller B that from 5 to 5 minutos go to controller A originating the error, then go back to B.

      I do have another volume preferred in controller B that stays in B.

      These are all windows Server.
      • Baldroega
        Baldroega
        6 Posts
        ACCEPTED ANSWER

        Re: After updating Fw for DS3524 Dual controller, started getting Error..

        ‏2013-03-22T09:50:07Z  in response to Baldroega
        Dont understand, im pinpointing this error to 3 specific logical drives, that are connected to the same servers and passes trhu the same switches.

        They are connected to two windows 2008 R2 Server hosting a Hyper-V Cluster failover