Topic
  • 2 replies
  • Latest Post - ‏2013-03-25T23:16:19Z by Giri_Daks
Giri_Daks
Giri_Daks
99 Posts

Pinned topic HPDAC1502E aznAPI -- Authorization Failure. (status 0x1005b5de)

‏2013-03-15T09:56:17Z |
I'm trying to set up the trace in the WebSEAL but pdadmin server trace set pdweb.debug throws the below error

Could not perform the administration request
Error: HPDAC1502E aznAPI -- Authorization Failure. (status 0x1005b5de)

any suggestion or resolution for the above error.
Updated on 2013-03-25T23:16:19Z at 2013-03-25T23:16:19Z by Giri_Daks
  • yn2000
    yn2000
    1086 Posts

    Re: HPDAC1502E aznAPI -- Authorization Failure. (status 0x1005b5de)

    ‏2013-03-15T17:55:10Z  
    Authorization Failure usually means that the user id that you use does not have the right to do the job or the server that will authorize you is not available. Of course you knew already.
    Possible Solution #1: Please use sec_master for testing. Of course you did.
    Possible Solution #2: Please check that Policy Server is running. Of course you did.
    Hmmm... I guess I am not helping you at all.

    Rgds. YN.
  • Giri_Daks
    Giri_Daks
    99 Posts

    Re: HPDAC1502E aznAPI -- Authorization Failure. (status 0x1005b5de)

    ‏2013-03-25T23:16:19Z  
    • yn2000
    • ‏2013-03-15T17:55:10Z
    Authorization Failure usually means that the user id that you use does not have the right to do the job or the server that will authorize you is not available. Of course you knew already.
    Possible Solution #1: Please use sec_master for testing. Of course you did.
    Possible Solution #2: Please check that Policy Server is running. Of course you did.
    Hmmm... I guess I am not helping you at all.

    Rgds. YN.
    Finally it worked after changing the permission for the group iv-admin on ACL default-management :)

    Thanks for your help !Regards,Giri