I am migrating to 8.6.x from the 7.1.x version of WXS. With that said, it appears that XIO is the preferred communication option to use going forward as the orb based approach is now deprecated.
With that said, when using a non IBM JDK based client, it appears that the IBM orb jars (ibmcfw.jar,ibmorb.jar,ibmorbapi.jar) are still required. If my grid will be using XIO, is there a setting I can use on the client side that would eliminate these jars from being a runtime dependency?
Pinned topic Can you set an XIO preference on the client side?
Answered question This question has been answered.
Unanswered question This question has not been answered yet.
Updated on 2013-02-28T16:21:46Z at 2013-02-28T16:21:46Z by joshuawhite929
jhanders 1200009V3S273 Posts
Re: Can you set an XIO preference on the client side?2013-02-27T22:16:59ZThis is the accepted answer. This is the accepted answer.Joshua,
The IBM orb jars should no longer be required if you are using the eXtremeIO (XIO) protocol instead of the ORB. There was a problem if you were using the ogclient.jar specifically where ibmcfw.jar was needed when using a non IBM JDK. This problem was resolved in version 188.8.131.52 with APAR PM78470.
I hope that fixes your issue.
joshuawhite929 06000288G652 Posts
Re: Can you set an XIO preference on the client side?2013-02-28T16:21:46ZThis is the accepted answer. This is the accepted answer.
- jhanders 1200009V3S
I was unaware that this was considered a bug. I will check it out in 184.108.40.206 now, thanks.