We got a new RD&T system last week (8.5). Supposedly the PC hardware simulates a z196. When I attempted to set AUTOIPL on z/OS, I got this message:
IGV010I IN PARMLIB MEMBER=DIAGXX ON LINE 5: 359
AUTOIPL WAS NOT PROCESSED, DUE TO AN ENVIRONMENT ERROR
Line 5 is this: AUTOIPL SADMP(NONE) MVS(0A80,0A82XX )
Explanation for the message is this:
Explanation: DIAGxx processing determined that AutoIPL actions cannot be performed on this system because required hardware support is not present.
System Programmer Response: Ensure that the required hardware support is present. If it is, search problem reporting databases for a fix for the problem; if no fix exists, contact the IBM Support Center. The required hardware support is present on all z10(TM) machines. On z9® machines, it is provided by Feature Code 9904 and hardware driver 67 or later (both are required).
Both a z9 and a z10 are 'less' hardware than a z196.
Is AUTOIPL not supported on RD&T?
What do I have to do to get it supported?
Thanks and regards, Barbara
Re: AUTOIPL on a RD&T system?2013-02-27T12:25:40ZThis is the accepted answer. This is the accepted answer.Hi,
noboday outthere to help?
Our IBM representative told us to post this problem/question here-in as the official support way for RD&T! - But since 5 days no single response!
Any supporter around?
Thanks for helping us,
Re: AUTOIPL on a RD&T system?2013-02-27T16:35:40ZThis is the accepted answer. This is the accepted answer.
- SystemAdmin 110000D4XK
The AUTOIPL feature is not supported by Rational Development & Test Environment (or the underlying zPDT).
Re: AUTOIPL on a RD&T system?2013-02-27T17:14:45ZThis is the accepted answer. This is the accepted answer.Hi Doug,
Thanks for this clear statement! That's clarifies the situation.
Is there a possibility or chance to raise an enhancement request for that?