Topic
  • 2 replies
  • Latest Post - ‏2013-02-08T05:34:05Z by SystemAdmin
SystemAdmin
SystemAdmin
849 Posts

Pinned topic RAA impact analisys - batch jobs are not returned in the result.

‏2013-02-06T09:25:25Z |
Hi , I have a question on the scope options in RAA's impact analysis wizard.

I use RAA with a few applications. One of the application (= A1) contains PLIs, Batch jobs and DB2s.
When I do the impact analysis from the data elements without selecting the application scope in the impact analysis wizard, step 2/3, the result diagram shows 21 batch jobs in direct impact and 63 batch jobs in in-direct impact. This is the result that I expect.
But I do the impact analysis from the same date elements selecting the application A1, the result diagram does NOT show the batch jobs in both direct and in-direct. I confirmed that the (21 + 63) batch jobs are linked to A1.

The question is if RAA's scope selection work correctly or not. Or is there any options or work required to get the correct result ?
Updated on 2013-02-08T05:34:05Z at 2013-02-08T05:34:05Z by SystemAdmin
  • SystemAdmin
    SystemAdmin
    849 Posts

    Re: RAA impact analisys - batch jobs are not returned in the result.

    ‏2013-02-07T20:31:00Z  
    Sounds like a problem in RAA, especially if you are on the current Fix Pack (V6.0.0.11) code. Please open an official PMR to have IBM service follow-up and investigate.
  • SystemAdmin
    SystemAdmin
    849 Posts

    Re: RAA impact analisys - batch jobs are not returned in the result.

    ‏2013-02-08T05:34:05Z  
    Sounds like a problem in RAA, especially if you are on the current Fix Pack (V6.0.0.11) code. Please open an official PMR to have IBM service follow-up and investigate.
    Hi Joanlook,

    thank you for your advise, I asked PSN to open the PMR.